TIMEleSS Multigrain Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Sample preparation ======
===== Starting material =====
<WRAP right centeralign  round box 35%>
{{:dac_experiments:mite-olivine.jpg?200|}}
Laser cut in a slice of recovered sample coated with platinum
</WRAP>
  * The material has to be ground down to an average grain size of about 2-3 µm while the maximum grain size should be less than 6 µm.
  * The fine starting material should be hot-pressed in a piston cylinder apparatus at around 1 GPa and 1200 °C. Depending on the assembly, a cylindrical sintered sample of few cubic millimeter is produced.
  * The recovered sample should be cut in fine slices using a diamond saw or a wire saw. Sometimes slices form automatically due to fast decompression.
  * The slices should be polished down to 10-15 µm thickness. 
  * Both sides of the slices should coated with 100 nm of platinum.
  * In each slices, 20 to 50 µm diameter samples are cut with a femto-second laser.


===== Diamond anvil cell loading =====
<WRAP right centeralign round box 35%>
{{:dac_experiments:sample.png?200|}}
Sample in the gasket hole
</WRAP>
  * A laser-drilled rhenium foil is used as gasket.
  * Dry MgO fine-grains are squeezed between carbide seats in order to produce 5-10 µm thick flakes that are employed as pressure medium. If one has to avoid MgO, the same can be done with KCl, alternatively (Make sure to dry the KCl properly to avoid too much water).
  * The sample is placed at the center of the gasket hole between the two MgO layers.